Toadette and the new upgraded Toad 2.0 are ready to join your display. This colorful 3D print model set captures their iconic look with playful proportions and clean details. Built with printing and assembly in mind, this set is a fun project that looks great once finished.

In the premium model package for Toad and Toadette, Patreon members will receive the upgraded Toad version 2.0 for free. This updated Toad will not be available for free on MakerWorld, making this package and future sales of the dual set the only way to get him.

About Toad version 2.0. He has been fully redesigned from the ground up with significantly easier printing and assembly for both the body and head. An alternate pose is also included, allowing Toad to be displayed with his arms resting naturally at his sides.

Dimensions: At 100% scale, Both Toad and Toadette stands approximately 5.7 inches (144 mm) tall. Scaling up should work fine, but scaling down may tighten tolerances and make assembly more difficult.

Print Profile:

For Toadette you’ll find her hair braids, eyes, and Mushroom Head in AMS form. For Toad you’ll find his Mushroom Head and eyes in AMS form, and an optional alternate pose with his arms restsing down.

Colors Used (Toadette):

Bambu Basic: White, Black, Red, Yellow, Hot Pink, Brown eSun PLA+: Beige (for skin)

Colors Used (Toad): Bambu Basic: White, Black, Red, Yellow, Cyan, Brown eSun PLA+: Beige (for skin)

Assembly Tips The mushroom heads for both Toadette and Toad are identical and follow the same assembly steps. The spots are labeled 1 through 4 for easy identification. When assembling, make sure the cut flat side of each spot is facing the bottom of the head.

(For Toadette): Do not assemble the pink dress and yellow trim first. The neck must be added at the same time, otherwise it will not fit properly.

(For Toadette): Glue the side hair pieces onto the face first. When the face and hair is fully assembled, insert it upside down into the mushroom head. It may feel like it does not fit at first, but place it straight in, then press the braids downward at an angle and it will snap into place.

Assembly Steps (Toadette) • Attach the shoes to the lower body • Insert the pin and attach the bottom pink part of the dress, with the dipped section facing the lower white body piece • Attach the white dress strip with the printed side facing down • Attach the top pink part of the dress • Attach the neck and yellow trim to the pink dress at the same time • Attach the red shirt • Attach both arms • Build the mushroom head following the instructions above • Assemble the hair with all spots, then attach the longer hair piece • Attach the hair to the sides of the face using the pins • Insert the face and hair into the head following the instructions above • Assemble the eyes by attaching the black and white parts first, then press them into the face • Attach the head to the body and the build is complete

Assembly Steps (Toad) • Attach the shoes to the lower body • Attach yellow trim to the white body, then attach the neck • Attach the blue shirt • Attach both arms • Build the mushroom head following the instructions above • Insert the face into the head • Assemble the eyes by attaching the black and white parts first, then press them into the face • Attach the head to the body and the build is complete

That’s it, your Toad and Toadette are all set. Thank you for supporting Playco3D and being part of the fun. Don’t forget to share your finished prints and tag @Playco3D so I can check out your awesome Mushroom Kingdom creations.