CNC collet storage blocks for the Gridfinity modular workshop storage system - they're both ER11 for now.

Gridfinity is the ultimate organizer for your whole workshop! Learn more at Find more Gridfinity accessories at https://bit.ly/3E2NxnZ

Parametric source files:

• Stupid Version: https://a360.co/3JznS7x
• Non-Stupid Version: https://a360.co/3M0PDar

These bad boys hold CNC collets - I only have an ER11 Snapmaker, so that's what ya get.

The stupid version holds collets in their little yellow boxes.

The non-stupid version holds the collets without the boxes.

There's no reason to use the stupid version. Just remember to keep the collets nice and oiled to prevent rust.

Gridfinity Tips!

• No brims or support required!
• Use any filament with an 0.6mm or smaller nozzle.
• Wider bins can curl, so maximize your bed adhesion if you're going big!
• All storage blocks are compatible with all baseplates!
• Most storage blocks are stackable!
• You can add 6x2mm magnets to the corners! They won't magnetize the contents.
• You can also use M3 screws in the corners.

Gridfinity was inspired by Alexandre Chappel's ModuBOX system, which is found at https://www.alch.shop/shop/assortment