This keyhole slot insert allows you to add a keyhole slot to any model you want to hang with a screw or nail.

Updated to show a little arrow inside the insert to show which direction is up

It accommodates #8-#10 (1") or #10- #12 (1-1/4") screws.

Simply add the keyhole insert negative to your model as a negative part in your slicer. This will create the cavity in which you press in the keyhole insert. It is a nice snug fit.

Supports None needed!

Scaling I wouldn't recommend scaling these since they have a very nice press in tolerance.

Orientation Everything prints upright with its flat side on the build plate

Print Settings .2mm layer height 15% grid infill 2 walls

Hardware Wall Anchors with Screws