The holy grail automatic double dispenser. Watch the video to see it in action. The most reliable double dispenser is now the Neo Sozu! I recommend printing that instead.

Hardware / Printing

• One M3x12 screw (or longer)
• Two M3 washers
• PLA, 2 walls, 10% infill, no supports
• 10mm and 3/8" flippers available

Assembly

1. Press a 10mm or 3/8" ball into the flipper depending on the flipper you print. May have to use a tool or step on the flipper to fully insert it. Don't damage your floor please!
2. Insert an M3x12 screw into the flipper, stack 2 washers on the screw, then install the flipper. Crank it down until it stops rotating freely.
3. Slowly back out the main screw 1/8th of a turn. Repeat until the flipper freely rotates.

This tile is part of my Counterweight Dispensers Pack. Check the others out.

• 180zu https://than.gs/m/1327652
• AltWave https://than.gs/m/1031259
• Anchor https://than.gs/m/1288074
• K-zu https://than.gs/m/1288115
• Overdrive Wave https://than.gs/m/1031248
• Wave https://than.gs/m/1031247
• Sailboat https://than.gs/m/1288126
• Tsunami https://than.gs/m/1031250
• Twozu https://than.gs/m/975596