Dogwood Vase
875 downloads · 2 years ago · Inspired by the petals of a dogwood tree. I chose to print this one in two colors but it would look
This model is restricted by licensing terms.
View license.
Inspired by the petals of a dogwood tree. I chose to print this one in two colors but it would look great in a single color too!
Supports None needed!
Scaling Can be scaled however you like.
Orientation The vase should be oriented with its bottom on the build plate.
Print Settings .2mm layer height 15% gyroid infill 2 walls Wall order: inner/outer
Filament & Hardware Filament:
- Overture Matte Black PLA
- Overture Matte Light Brown PLA
Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://hendricks.design/links/
This model is restricted by licensing terms.
View license.
Skeleton Leaves - Willow
Skeleton Leaves - Dogwood
Skeleton Leaves - Alder
Diffuser Type 1 - Lamp accessories by Lunfardo
DRAPED ELEGANCE | Table Lamp
DELTA RIDGE | Table lamp E14 & E27 fast-print
KETE | Pendant Light E27 & E26 fast print
Swamp Mana Vase -(Magic The Gathering Inspired)
Shoji Lamp 2
Seismic Vases - Cylindrical
Ornate pot doctor
Mountain Mana Vase (Magic The Gathering Inspired)
Plains Mana Vase -(Magic The Gathering Inspired)
Minimalist Modern Pen Holder, Minimal Desk Organizer, Pencil Cup | Vase mode
Gothic Pattern Planter -Square
Island Mana Vase -(Magic The Gathering Inspired)
Aztec Pattern -Taper Vase
Threaded Mini Five Gallon Bucket!
Forest Mana Vase -(Magic The Gathering Inspired)
Beautiful! I love that it’s multicolor without needing to switch colors a million times. Shouldn’t take much longer for it to be printed multicolor than in a single color.
Thank you! Yeah if I ever design something for multicolor it will almost always be by layer to reduce waste and make it easy for people who don't have multicolor printers.
Ohhh I love it!
Do you use "Spiralize Outer Contour" on this?
How do you do a multicolor print like that?
I can't seem to get this to open in Bambu Slicer pre painted, and the painting tools in the slicer are painfully bad... Any idea what could be wrong?
To see this the way the designer intended, open it in OrcaSlicer.
I used the "Switch" filament on the right side on line 50 & 660. But I did scale it, so might not be the correct lines for your model. But you can right click on the right bar and set "swap filament".