Upgrade your kitchen with this minimalistic and modular cup shelf system. Connect as many cubes as you want. Some parts (like 1x1 corner top) have to be mirrored in the slicer.

Size: 125x125x120mm outside 118x118x120mm inside Scaling can be possible (you might need to experiment with the connector due to tolerances)

Print settings: cubes: 0.2mm layer height 2 walls (with bright filament like white you might see the infill trough..) 15% infill brim position the seam in a corner, it is less visible then

connector: 0.12mm layer height 4 walls 30% infill If you have problems getting the connector in experiment with X-Y expansion offset.

Additional hardware: Depending on your wall you will need dowels and screws/hooks.