This is a collaborative project with Cinderwing3D A cute little mushroom dragon with its own shelf.

Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups.

The holder has a screw-hole diameter of 5.5 mm. If you want a huge version, scale up the shelf and use the holder_for_upscaling – the only difference is the screw-hole size of 3mm that will be usable when scaled.

Instructions for single color

• Print your dragon, the top, bottom and holder of the shelf
• Print as many spots for our shelf as you want. They are provided in three different sizes
• Glue the top onto the bottom
• Glue on your spots
• You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
• Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.

Instructions for multi color

• Print your dragon, shelf and holder
• You can either screw or glue the holder onto your wall. There are various glue or tape products for wall fixation out there. I used 3M Tape. Old fashioned screws and dowels are the most reliable fixation.
• Insert the shelf by moving it horizontally onto the holder until the holder is completely inside the cutout. Then proceed to move the shelf down and the holder locks.

Print settings Required build volume: 210 x140 mm

Material: PLA Print direction: files are rotated correctly Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Infill: 15% Build plate adhesion type: none