3D MODEL DESCRIPTION Completely print in place with colored models included - cute fun and highly flexible with 2 versions available.

3D PRINTING SETTINGS Fully print in place with no support or brim needed so long as you have good bed adhesion.

I kept the wall thickness at 0.42mm with 2 walls.

Speed was 200mm for the walls.

Gyroid infill recommended at 15%.

If printing in silk I recommend it increase the model size by at least 50 percent with a minimum of 3 wall, 25% infill, slower printing speeds and a higher nozzle temperature. (highly dependant on the silk used)