Magnet Fidgets Set

A set of magnet fidgets. 5 designs for a different feel. 2 different magnet sizes which give a different strength of click. SET1 instructions, harder click, , takes 6x2mm magnets, 6 in each side. so a total of 12 magnets per complete fidget. layer pause ay layer 14 to insert the magnets. IMPORTANT keep all magnets connected and the same way up for the first half. make sure they are inserted the same way as you holding them. for the second half you need to flip the magnets over. so once printed and you remove off the plate and the fidgets together the magnets will all be the same way up. If you do get muddled which way up they are then hold them over an already inserted magnet, for side one they should not oppose, and for side 2 they should oppose side one. SET2, easier click, takes 5x1mm magnets, again 6 in each side making a total of 12. Layer pause at layer 9 follow the same insertion instructions as above.

I suggest printing just one fidget at a time to start and place near the front of the build plate for easier insertion. if you print all in one go its a lot of magnets to do in one go. the cavity is just big enough for the magnet, you will need to push them in and make sure they are pushed down and seated correctly, if your struggling with your finger use a tool to push down.

ignore any floating regions warnings.

0.2 layer, 15% infill