Here is cow fully articulated fan art toy, this toy is perfect for anyone who's a fan of minecraft, This model is Print in place and comes pre-painted in bambu studio, every Limb and head moves, The design can print with out supports but I recommend using them to make the design look better, And once you've printed off the cow you will have to release the legs, They are tight because of the latch to make them easier to print, all you have to do, to release the legs, is put a piece of paper towel in-between some pliers and use the pliers to gently rotate the legs down into position, you can do this with your fingers but I wouldn't recommend as the legs are quite hard to grip onto. But don't worry about the joints, there very strong and I've been extremely ruff with them and have failed to break the joints. check picture for reference. Print settings, Nozzle size 0.4mm, layer Height 0.2mm, Supports needed, Support type normal, Support placement Touching build plate, Support over hang angle 50%, Print speed 50ms, Infill pattern grid, Infill density 15%,