Here is Bike Phone Holder Mount, This mount is an adjustable phone mount designed for most phones and handle bars, the adjustable lock nut design allows for 180 degrees of range allowing you to adjust your phone into any orientation you like while providing a strong and sturdy base to hold your phone in place even over ruff terrain. To assemble the Mount first screw the top and bottom handle bar mounts onto your bike holding them in place as you screw the two screw one in each side until evenly tight. Next adjust this mount to be facing upright and the lock-in piece facing towards your phone, Next push the spacer into the top of the mount before pushing the phone Cradle into the front of the spacer's lock-in Piece, I recommend Adjusting the position of your phone now, Next Place the screw through the back of the mount Spacer and Screw into the Phone Cradle until tight Locking all 3 in place, next Screw the Phone Screw through the right hand side of the Phone Cradle, after the Ball socket is inside of the phone cradle Push the phone nut onto the end of the ball joint until it click into place, You may need to heat the end of this nut if your having trouble attaching it. Print settings, Nozzle Size 0.4mm, Layer Height 0.2mm, Infill 20%, Wall Count 3, Print speed 100mms, Supports needed for everything expect the phone nut and screw, Support type normal, Support placement everywhere, Support Threshold angle 35