Tic Tac Toe

361 downloads · 4 years ago · This Tic Tac Toe game prints-in-place as one part. Optionally, you can print the letters in differe

This model is restricted by licensing terms.

View license.

Description

This Tic Tac Toe game prints-in-place as one part. Optionally, you can print the letters in different colors and glue them in place. Its roughly a 110mm square as downloaded, no supports

Printed on the Mulcore.

Note: Assembly model for reference only.

Support and Licensing If you would like to help support more free models please consider joining my Thangs Membership To get permission to sell physical copies of my models by joining my Patreon

Tags:

Community Makes (3)

Community Makes (3)

Discussions

theadamcaskie2 years ago

JasonHartman3 years ago

Hi there! Total noob here - got my first printer this week. Elegoo Neptune 3 Pro. Just printed this one out today. I wanted it to be a little more "pocket sized" for my daughter so I scaled it down to 66%, but all of the pieces are fused to the flat surface and won't rotate. I'm assuming there should be a gap around all of the pieces but because I shrunk it, that gap size is smaller than the nozzle can replicate?

I'm guessing it would be fine if I print again at 100% but I wanted to make sure there wasn't some other "bed adhesion" or "support" setting that I messed up that caused this.

Thanks!

3dprintingworld3 years ago

There are IO's indented but not printed separately because they were to small to print and glue into place.

JasonHartman3 years ago

I don't see a reply button on your comment, hopefully you see this. I did look at that keychain version first but it appears that it's blank with no X's and O's? Is that accurate?

3dprintingworld3 years ago

I think its possible to print at that small but it makes it a lot harder. Did you see this one?https://social.thangs.com/m/252971