A collection of simple hangers for your tool wall, craft room, or anywhere around the house. There should be something for everyone in this collection.

They are **surprisingly strong when printed with 4+ walls/perimeters**. Almost every model comes with thin variant that just uses less material. **When in doubt, go larger!**

All of these are **printable without support**, though the TH_Mini_long_braced does need decent cooling for the overhangs. **If you are printing with something like a stock ender 3** that has pretty weak part cooling, I'd slow down for the first print just to make sure you don't get much sagging then bump up the speed if you feel comfortable.

**Ideally you want it as a solid part**. PLA is perfectly fine for most but you could print in PETG or ASA/ABS if you felt so inclined.

Tool Wall Hangers

TH_Large_Right.stl

Needed to Mount a US-XG-6POE under a desk. Drafted this up and very happy with it! 

No supports needed. If printed in a high-temp PETG or ASA you can likely get away with just the front mount. However, adding the rear wouldn't be bad insurance. The Switch can get warm enough that PLA may not be a good long-term solution with its lower glass transition temp.

Unifi US-XG-6POE Mount

US-XG-6POE_Front.stl

Simple chin mount for TLD Stage helmet. No Supports needed. Recommend using thin foam between mount and chin bar to prevent rubbing and vibrations.

Troy Lee Designs GoPro Chin mount

troy lee designs GoPro Chin mount

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

trailfeatures

Tool Wall Hangers

Unifi US-XG-6POE Mount

Troy Lee Designs GoPro Chin mount