moved my fillament holder to a top mount on the printer
made a fillament sensor holder bracket and moved the fillament sensor above the printer head just had to extend the wires which i ran along the printer head cable using cable clamps print fillament sensor holder bracket flat with support
fillament bracket slides on the top use cable tie to hold in place
made a cable bracket to fit where the fillament sensor was to move cable out further more in line with print head 
used some old ptf tube with cable clamps they act like cable chains
cable bracket use one screw and one small cable tie 
Added fillament guide bracket to top spool holder added torch light to top spool holder
used a torch i bought from aldi 16mm barrel if you wint to make clasp to fit larger torch just scale up or down
 added cable holder to frame
see pictures for fitment
 all printed on my kobra 2 print speed 170mm
top spool holder link https://www.printables.com/model/546414 many thanks
  

Kobra 2 Mods

kobra 2 fillament sesor bracket.stl

clasp barrell.stl

filament guide.stl

fillament guied barell.stl

torch Clasp-export.stl

cable holder to frame.stl

kobra 2 cable clamp.stl

ThangsBambuContest
Printed PLA 
Initial layer hot end temp 210 build plate 60
Normal print temp 200 hot bed 60
Print speed 75
Infill 75
Walls 3mm
Support normal everywhere angle 86 triangles
screw only scale X975% Y97.5% Z100% for looser thread.
print rest at 100%
see picture for print orietation.
Build plate adhesion used brim you can use none if you have good adhesion makes deburring easer. 
Use 2 x countersunk rib head 10G x65mm TPI8 screws for strength in the clamp and screw.
Use 3 x counter sunk black timber screws 4mm x 25mm for extra strength.
Glue caps in
Rubber pads 19dia self-adhesive.
DO NOT OVER TIGHTEN OR USE Excessive FORCE on THE CALMP
Do not leave in direct sunlight
Do not use as a standing anchor point when stick is in the clamped position


Walking Stick Holder ThangsBambuContest

clamp m12.stl

used 2 3mmx12 shs screws
3 cable ties 2.5 x 100mm
build no support

mega pro cable suport for printer base hot bed

endcc.stl

anycubic mega pro hotbed cable support

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Fred2013

Kobra 2 Mods

kobra 2 cable clamp.stl

Walking Stick Holder ThangsBambuContest

mega pro cable suport for printer base hot bed

anycubic mega pro hotbed cable support