I needed to mount my monitor for my reversing camera. So I designed a mount for the unused Button locations.

VW T5 Cockpit mount

Fuß.obj

Mount_16mm-3,75.obj

The prIvate OpeN Source Network Attached Storage or short I.O.N.S. N.A.S. was created because i needed an NAS for my Data. Sadly I couldn't find a design that fulfilled all my wishes.

As some people probably already recognised the outer design is somewhat based on/inspired by the Xbox Series X.

The NAS is designed for two 63,5 mm(2,5 inch) drives for storage and a Raspberry Pi 4 as the brains of operation, but you can probably use any small single board computer.

The I.O.N.S. N.A.S. is able to house a 120mm Fan (I had a NF-F12 5V in mind). It's not necessary for most cases though.

If you would like a version without the possibility to hang it on the wall or Without the Icon, just leave a comment.

Due to the size of the parts I designed them to be printable with a 1mm nozzle.

Software and Electronics:

The software part is relatively simple. I'm using OMV on the raspberry and it works great. There are many tutorials if you need help with the installation.

There is one important information you need to know if you want to build this NAS. A raspberry isn't able to run two 63,5mm hard drives on its own Power Supply. Due to this you will need SATA adapters with an external power Supply. Sadly I wasn't able to find one so I opened "normal" ones and replaced the existing connection with an external 5V USB Supply. As you can see in the picture (I know it isn't up to code but that's what I had on hand).

I.O.N.S. NAS

case

HDD_SATA2

Drive-tray

pi-plate

I wanted to have the possibility to switch between the caffeinated and decaffeinated beans. So I designed this Part.

Print it with 100% infill in PLA.

Due to the weird shape of the machine I didn't suceed to model the exact form on the ground-coffee-inlet side. Therfore you have to heat this part in hot water and form and cut it accordingly to your mashine.

DeLongi coffee separator

knob

cone

I'm a mechatronics engineering student from Hannover, Germany. A few years ago I designed a gigantic 3D Printer with some friends.

titan-lg.leogos.de

Ich Studiere Mechatronik in Hannover. Vor ein paar Jahren, habe mit ein paar Freunden einen gigantischen 3D Drucker entworfen und gebaut.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Marlon Janisch

VW T5 Cockpit mount

I.O.N.S. NAS

DeLongi coffee separator