Pebble 2 (SE/HR) smartwatch replacement side plates and buttons.

This model has two pairs, one plain pair, one with the pebble logo on the one button/back button side.

The plates and buttons are 3D printed as one interlocking part. They are mechanical and have a satisfying click when pressed. Buttons can be coloured using permanent ink (Sharpies work well) or acrylic paint, and you can either colour both sides or just the backs.

When handling the new buttons, please be gentle as the material is brittle, and the button plates will snap if they bend too far.

Please note that due to the nature of this design, the watch will no longer be waterproof.

Silicone craft glue or “B7000” (mobile phone glue) applied in a fine layer are the best options for fitting the buttons.