tracking pixel
ohmytallest

Ender 5 Control Shroud with Pi (separated)

by

ohmytallest

Follow
Follow
Remix Model
Like
Ender 5 Control Shroud with Pi (separated) 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
1 Likes2 DownloadsOctober 19, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4802237.

Update (Mar 22, 2021): Version 2 is now live!

Changes in the version are as follows:

  1. Rotated ventilation slots on the top of the Raspberry Pi case section to allow one of them to be used for passing through a camera ribbon cable to the connector on the Pi.

  2. Enlarged the dovetail and slot while also deepening the angle of the sides of the dovetail to make it a true, non-directional friction fit.

  3. Adjusted the cutout for the ethernet port on the end cap as it's currently a bit fiddly and easy to snap when installing.

  4. Added a ramp for the SD Card slot to make sliding it into place easier.

Overview:

I liked dgeddings' model that this is remixed from, but like others in his comments was annoyed with the orientation of the Pi in the model. So I separated the Pi enclosure from the LCD shroud and added a dovetail (with stop) to make the entire process tool-less. Otherwise this is the same model as his.

One thing of note, I designed the dovetail to flip the Pi around in relation to the shroud but as this is a dovetail, friction should allow it to be installed in either direction.

Notes:

You need to print one of each file ending in _v2 to get the correct version.


1 Likes2 DownloadsOctober 19, 2021




This model is restricted by licensing terms. 
1 Likes2 DownloadsOctober 19, 2021
This model is restricted by licensing terms.