An elegant soap dish. The slanted indentations ensure that the water drains into the tray.

Size assembled: 122 x 90 x 36 mm Don't forget to post your makes!

Print settings Required build volume: 130 x 130 x 80 mm Material usage: 80g in total Print time: 9h in total

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm – 0.28 mm Outer walls: 3 Infill: 20% Build plate adhesion type: none, a brim if you have bad bed adhesion

Watertight printing - If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.

If you experience any problems, please feel free to contact me on twitter or Instagram