Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4586681.
This model was <a href="https://www.youtube.com/watch?v=XasxSY-Zbnc&t=2s">featured on The 3D Printing Nerd</a>
We love the Star Wars Kit Cards by <a href="https://www.thingiverse.com/benzz88/designs">benzz88</a> <a href="https://www.thingiverse.com/edabot/designs">Edabot</a> <a href="https://www.thingiverse.com/nakozen/designs">Nakozen</a> and <a href="https://www.thingiverse.com/delman83/designs">delman83</a>
After designing the millennium falcon kit card, I thought I would try to design a tie interceptor to go with the other star wars kit cards we've printed for his office.
Make sure to check out: <a href="https://www.thingiverse.com/thing:4582264">My Millennium Falcon Kit Card</a>
<a href="https://www.thingiverse.com/thing:1195099">Tie Fighter Ornament by Edabot</a>
<a href="https://www.thingiverse.com/thing:4041225">X-Wing Kit Card by Nakozen</a>
<a href="https://www.thingiverse.com/thing:4319646">Y-Wing Kit Card by Nakozen</a>
<a href="https://www.thingiverse.com/thing:4300824">A-Wing Kit Card by Delman83</a>
<a href="https://www.thingiverse.com/thing:4285576">B-Wing Kit Card by Delman83</a>
This was made to fit when printed on my homemade hypercube300 printer which is not the highest precision printer in the world, so you may have to adjust the holes, or use a little glue depending on how dialed in your printer is. Adjusting the z-scale slightly up or down without changing the x & y scale can help as well.
There are two versions included. One with a ring for hanging, or using as an ornament, and one without a ring.
Printed card is 120mm X 120mm to fit on most printers. Assembled Model is roughly 82mm X 63mm X 50mm.