1:6 Scale Adirondack Chair Designed to be 3d printed flat and then glued. Print one of each number.  The Assembled STL is not intended to be 3d printed, but is a depiction of the assembled 3d print.

Adirondack Chair 1:6 Scale

lollygagger.STL

3d printable grab handle to be fastened with 4 screws.  use 5+perimiters for strength 20% or more infill.  ABS if being used outdoors or in a vehicle.

Angled Grab Handle 4 screws.

Line loc for ~1/8" diameter cord. also works with bungie cord.

Cord Line Loc

3d printable 5" shower drain grate cover for old school set in concrete drains. 

Print with 5 perimeters, 20% or more infill. Material of choice.

5in Shower drain grate cover

Lund Boat Compatible Seat Hole and Ski Pilon Plugs.  Print out of TPU.

Lund Boat Compatible Seat and Ski Pilon Plugs

Lund Seat Hole Plug.STL

Off Shore Planer Board Holder for Lund 45deg track.  Print at 15-20% infill TPU only.  Will not work with non flexible filaments as the fins need to flex into the track.

90deg version here:https://social.thangs.com/m/73593

Off Shore Planer Board Holder Lund Track 45deg.STL

Off Shore Planer Board Holder for Lund 45deg track.  Print at 15-20% infill TPU only.  Will not work with non flexible filaments as the fins need to flex into the track.

Off Shore Planer Holder Lund Track 45deg.STL

Off Shore Planer Board Holder for Lund 90deg Track.  Holds (1) planer board with or without tattle tale flag.  Print in TPU 15-20% infill.  Will not work with pla or ABS as fins have to flex to fit into the track.

45deg version here: https://social.thangs.com/m/73596

Off Shore Planer Board Holder Lund 90deg Track

Off Shore Planer Board Holder for Lund 90deg Track.  Holds (1) planer board with or without tattle tale flag.  Print in TPU 15-20% infill.  Will not work with pla or ABS as fins have to flex to fit into the track.

Collection of 3d printable cup, rod, and flag holders compatible with Alumacraft brand Alumatrac gunnel tracks as seen on the Alumacraft Voyageur 175 Boat.  I printed these in TPU with supports at 30% infill.  Non-flexible filaments will not work as the flexibilty is required to mount them.

Alumacraft Alumatrac compatible cup, rod, mounts

ALUMATRAC CUPHOLDER vertical.STL

Set of plugs in various hole sizes that are compatible with Mercury brand outboard propeller's PVS system.  7mm 9mm 12mm and solid models.  I printed these in TPU at .2mm layer height 60% infill two perimeters.  These would probably work with ABS as well with a slot relief like the OEM Plugs have.

Mercury Performance Vent System Compatible Plugs

PVS PLUG SOLID.STL

Holder for a Cannon 8lb Downrigger weight, scale up or down for your size downrigger weight.

Cannon 8lb Downrigger Ball Holder.STL

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

ericnistler