tracking pixel
Tyler B

Simple Hard Drive Bracket (Long)

by

dtylerb

Follow
Follow
Remix Model
Like
Simple Hard Drive Bracket (Long) 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4151949.

This is a simple bracket for installing a 2.5" hard drive or SSD in to a 3.5" bay. It is a longer design than some of them and has all three of the standard screw holes found in 3.5" hard drives which is necessary in certain cases.

If you'd like a bracket that takes less time to print, is shorter, or if you have some other requirement that this bracket doesn't meet, check out my other hard drive brackets at the following link: https://www.thingiverse.com/dtylerb/collections/my-hard-drive-brackets

The holes on the side of this bracket should allow you to self tap a #6-32 UNC screw. (The standard ones that are used with 3.5" hard drives, not the M3 screw which has a finer thread and is generally used for optical drives and 2.5" drives - although if you find the hole too small for the 6-32, you could try an M3.)

If you liked this design, consider a tip or post a make!


0 Likes3 DownloadsOctober 18, 2021




This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms.