Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3494297.

UPDATE: A Rev2 Corner Foot has been added. It's been beefed up a little, the side tab has been widened, and side frame rail now rests in the bottom of the tab.

The printer needed some feet.

Just something to get in between the metal frame and the table, quiet it down.

These are they.

My Z-braces (GulfCoast Robotics) leave the front and rear bottom frame edges exposed, so it was a corner wrap for the 4 outer corners and a full wrap for the gantrys.

Doublestick tape and some thin tool chest foam drawer liner for cushion.

The printer gets lifted 2mm by the feet plus whatever thickness your tape/foam is.

I'm liking it so far: seems quieter. :-)

STL, STEP and SLDPRT included.

If you would be so kind, please post your Makes.

Thank You!