Upload for Search
Search By Text
Upload for Search
Search By Text
M

EDGE 540v3 73" - Elevator/Rudder Arms - 3DLabPrint

by

MakeItMakeItMakeIt

Follow
Follow
Like
EDGE 540v3 73" - Elevator/Rudder Arms - 3DLabPrint by MakeItMakeItMakeIt full viewable 3d model
Loading preview...
1 Likes0 DownloadsApril 14, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

1 Likes0 DownloadsApril 14, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4378581. UPDATE: They needed a slight change as I designed these before I actually strung them. The pull-pull cabling was touching the inner fuselage: no more. If you have previously downloaded these before 6/2/2020, download them again. The 3D printed Elevator and Rudder Arms in the kit were just flat plastic, and utilized screwing the x-arms to the printed plastic. I wanted something stronger, so I designed these to embed the servo-supplied round control arms into the new printed arms. I use Cura, so: eSun PETG, Normal .15 Resolution, 95% Infill. Print the arms with the ribs UP: they need Support, Touching the Build Plate. I used 4 ea M3 x 8mm self-tapping screws for each arm. I cut the excess screw with some side cutters and ground them smooth with a Dremel stone wheel. If you/d rather a cleaner inside look, there are covers that screw on. The retainer screw will need to be an M3 x 8 The covers are printed with the letters UP, .15 Resolution, 15% Infill, Support Touching Build plate.




1 Likes0 DownloadsApril 14, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

1 Likes0 DownloadsApril 14, 2022

Community Uploads

No photos added yet, be the first to upload a photo!