tracking pixel
Robert V

Top Left Rebuilt_ascii(IJF).stl

by

Jakk Von Swaggr

Follow
Follow
Remix Model
Like
Top Left Rebuilt_ascii(IJF).stl 3d model
2D
3D
Makes
Be the first to upload a make
0 Likes6 DownloadsSeptember 17, 2021


Buddy has a Sea Doo Spark that is missing a cupholder, so I took a stab at making an adjustable one. To assemble you will need 4 washers that are 0.5mm thick with a 5mm diameter hole. (Alternatively you can use 2 1mm washers but with a little more friction.) Additionally you will need a length of 4mm wire approximately 205mm in length or appropriate length pins. At the center of the wire you will mark approx. 5mm on either side. Bend at 5mm marks until right angle is formed, repeat process on other mark in same direction to form a U shape. Feed the U through the top of the Top Left and Top Right pieces, add washers, add bottom and bend exposed ends on the bottom to keep assembly together. 4mm holes are on the back of the Top Left and Top Right, which are for a little bit of bungie cord in a crisscross pattern to keep the rear closed and adjustable. For mounting Use Mount Plate and the main assembly has the equivalent of a M8 x 1.25.


0 Likes6 DownloadsSeptember 17, 2021




0 Likes6 DownloadsSeptember 17, 2021