I like to use mason jars around my workspace as pencil, paintbrush, or tool holders.  but to get them off of my desk, I designed this clip to turn them into containers that I can hang on my SKÅDIS pegboard.

Printed from PLA or ABS, this flexes just enough to snap snugly around the ridge that is just below the jar threads (so that you can still screw on lids if you like)

Prints easily upside down, without support.

Versions:
 - v3, was experiencing a lot of stringing when printing with ABS, so I filled in the sides with a supporting interface layer. 0.8mm thick so it doesn't increase print time much but greatly increases strength and print quality.
 - v2, moved hooks up flush to top, so the model can print without supports, added bevels or chamfers everywhere possible to reduce overall volume, and minimize printer jerking

Skadis Mason Jar Container

I like to use mason jars around my workspace as pencil, paintbrush, or tool holders.  but to get them off of my desk, I designed this clip to turn them into containers that I can hang on my skadis pegboard.

This is a remix of the [Gridfinity Paint Shelf by bigbrisco](https://thangs.com/designer/bigbrisco/3d-model/%23Gridfinity%20Paint%20Shelf-62255) who graciously shared the Fusion 360 file for his original design.

With the built-in Gridfinity ability to build a tiered shelf, I found both the need for a large stepped paint shelf and the height of the original model excessive.  I wanted to print a 1x4 paint shelf (4x being the max that fits on my 220mm print bed) that prints quickly with a minimal amount of material.  I may go through and slim this down further...

(Currently looking into standardized riser heights, so I'll probably update this file shortly)

I've attached a photo showing which paints I own fit in the holes, arranged from tight in the left to loose on the right, and don't fits standing in the back looking on in envy.

#Gridfinity slim Paint Shelf

THis is a remix of the [Gridfinity Paint Shelf by bigbrisco](https://thangs.com/designer/bigbrisco/3d-model/%23Gridfinity%20Paint%20Shelf-62255) who graciously shared the Fusion 360 file for his original design.

With the built-in Gridfinity ability to build a tiered shelf, I found both the need for a large stepped paint shelf and the height of the original model excessive.  I wanted to print a 1x4 paint shelf (4x being the max that fits on my 220mm print bed) that prints quickly with a minimal amount of material.  I may go through and slim this down further...

Making and sharing printable figures at [INSPYR3D](https://www.patreon.com/Inspyr3d)

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

Harper Crafthall

Skadis Mason Jar Container

#Gridfinity slim Paint Shelf