tracking pixel
Greg's M

ADXL345 Mount for Hemera (for auto calibrating Input Shaper)

by

GregsMakerCorner

Follow
Follow
Remix Model
Like
ADXL345 Mount for Hemera (for auto calibrating Input Shaper) 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes8 DownloadsOctober 16, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5001570.

Simple ADXL345 mount that I designed for an e3d Hemera, for the purpose of running input shaper to remove resonance (ghosting) artifacts. Open SCAD file is included if you need to make adjustments (please remix if you do).

Materials needed:

Mount the ADXL345 with the two m3x4mm screws. It will be close to the SMD components but if your screw hole spacing is correct, they should fit fine. Double check that it's not touching any of the solder after tightening- you don't want to short out your components.

Adjust the screw_pos_1 with Customizer and reprint if your screws won't fit right. (I'd recommend in increments of + or - .25mm)

Once you have mounted the AXL345 follow the instructions here for wiring and then configuring Klipper: https://www.klipper3d.org/Measuring_Resonances.html#input-shaper-auto-calibration


0 Likes8 DownloadsOctober 16, 2021




This model is restricted by licensing terms. 
0 Likes8 DownloadsOctober 16, 2021
This model is restricted by licensing terms.