tracking pixel
Lars

Auto-Rewind Spool Holder for Spannerhands Spool System (MM)

by

Exerqtor

Follow
Follow
Remix Model
Like
Auto-Rewind Spool Holder for Spannerhands Spool System (MM) 3d model
2D
3D
Makes
Be the first to upload a make
This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms. 


Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3608441.

NOTE!: I've done a print now and i ran into a little problem. The way thing's currently am (i haven't got time to fix it atm) you will have to do a little postprocessing on the axle shaft because it's just a smudge to tight linearly. At the spring end of the axle just cut away the little ledge (1mm ish) twards the spool to leave a little extra length so that the bearings don't pinch. Once that's done assemble an check, you might have to sand down a little on the spring to!

Figured why not have a Multi Material spool holder for the Spannerhands Spool system (even though it's hidden most of the time).

Need to use the spring/clutch assembly, nuts, retaining clips etc. from the original thing: https://www.thingiverse.com/thing:3338467

The axle and axle holder (two holders needed!) from this thing: https://www.thingiverse.com/thing:3490353

And the 1KG version of the Spannerhands Spool System V3: https://www.thingiverse.com/thing:2119644

I borked something so instead of doing "Center and Arrange Models" in S3D you have to do "Align Selected Model Origins" to make the two parts line up. How it works in other slicers i have no idea. Other than that it should be all good.


0 Likes3 DownloadsOctober 18, 2021




This model is restricted by licensing terms. 
0 Likes3 DownloadsOctober 18, 2021
This model is restricted by licensing terms.