Phone Stand

Here is another rat, this time you can use a piece of filament as the tail, just melt the end a bit and put it in the modeled hole. If you can, print in flexible filament, it makes for a great stress toy.

Here is another rat, this time you can use a piece of filament as the tail, just melt the end a bit and put it in the modeled hole.

This was really just a learning tool for me, but I thought it was cute so I am gonna share it with you guys.

Chibi Among Us Astronaut

This is the third major revision of a set of retractable landing gear I am working on for a pretty hardcore RC aircraft

Landing Gear Mk3 v16.stl

Clip this onto the back of your Meta Quest 2 elite strap to hold this specific battery, dont know if it works with anything else as I havent tried,

Anker PowerCore 10000 Clip for Elite Strap

Requires 608 ball bearings in order to function properly.

Fidget Spinner

Stick a C6-3 rocket motor in this and put a rod though the center for launching, and then light it off, the rotation caused by the motor exhaust will stabilize the monocopter, and create lift, causing it to fly.

Rocket Powered Monocopter

A model aircraft I designed, has no real function other than decor/toy.

I am however working on a function version that will be released in a while.

Blended Wing Aircraft (temp name)

A simple glider that can be shot by a rubber band. Comes with pitch trim tabs The tail should be printed detached and flat, then glued into the slot at the rear of the plane. Print with 50% infill.

SIFF Glider-02 Simplified v2.stl

Clip a rubber band into the end of this stick in order to make launching my series of gliders easier.

Stick launcher for glider

A simple glider that can be shot by a rubber band. Comes with pitch, yaw, and roll trim tabs. Make sure to fold the creases in the wings for best performance, even glue them for extra rigidity. The tail should be printed detached and flat, then glued into the slot at the rear of the plane. Print with 50% infill.


SIFF S Glider-01a v5.stl

A simple glider that can be shot by a rubber band. Comes with pitch, yaw, and roll trim tabs. make sure to fold the creases in the wings for best performance, even glue them for extra rigidity. The tail should be printed detached and flat, then glued into the slot at the rear of the plane


A simple glider that can be shot by a rubber band. Comes with pitch, yaw, and roll trim tabs. Make sure to fold the creases in the wings for best performance, even glue them for extra rigidity. The tail should be printed detached and flat, then glued into the slot at the rear of the plane. Print with 50% infill

SIFF Glider-02f v10.stl

A simple glider that can be shot by a rubber band, make sure to fold the creases in the wings for best performance, even glue them for extra rigidity.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

Acai