lee201028001413 followers

Multiboard Dual Snap Hook - Heavy Load Top Snap

58 downloads · 5 months ago · This hook is designed to be used with a Multiboard tile. It's extremely strong as it incorporates th

Description

This hook is designed to be used with a Multiboard tile. It's extremely strong as it incorporates the Raised Heavy Weight-Bearing Hook Snap at the top and the regular, standard-fit snap at the bottom. This will hold much more weight than any of the single snap designs already available.

This model was tested without supports using PLA and a Carbon X1 and A1-Mini. Other models and materials will likely require supports.

Use 3-perimeter wall thickness, 0.2 mm layer height, 15% infill, and test for supports.

For those looking to create similar models, ensure your snap spacing is exactly 50 mm on center for a proper tile fit.

Community Makes (1)

This came out really well. Strong and clean with minimal filament and maximum strength.
I found plenty of hooks and hat hangers but IMO they all missed the mark in one way or another. While this isn’t a purpose built hat hook, it is a really solid hook that has the length I needed and the hooky-ness that I needed.

Community Makes (1)

Discussions

Graham’d’ma5 months ago

This came out really well. Strong and clean with minimal filament and maximum strength. I found plenty of hooks and hat hangers but IMO they all missed the mark in one way or another. While this isn’t a purpose built hat hook, it is a really solid hook that has the length I needed and the hooky-ness that I needed.

PrinterBambu Lab P1S

MaterialPLA

Infill density15 %

SupportsNone

Parkker773 months ago

It would be great if at the tip it angled back a bit toward the grid so it could be used upside down for example under a cupboard so one could hang a coffee mug from it.