RuvenBals14K followers

Twister Fidget Toy

549 downloads · 2 years ago · You need: 6 Pieces. You can also connect more but, some of the higher configurations are not symmetr

Description

You need: 6 Pieces. You can also connect more but, some of the higher configurations are not symmetric.

Print Settings: Standard settings. No supports or any special settings needed.

Assembly: You can just watch this Video: https://youtu.be/yYEv9C052pg The longer End should be pushed into the middle of another Piece. Then build a Ring and that's it. You can take a look at the pictures for guidance.

Pictures by Coco3D Cocos Instagram Cocos Thangs

Tags:

Community Makes (4)

Community Makes (4)

Discussions

magician.1442 years ago

magician.1442 years ago

PrinterPrusa MK4

MaterialPLA

Layer height0.2 mm

Infill density10 %

SupportsNone

magician.1442 years ago

The easiest way to put it together is to join two of the pieces, repeat for all six so you have three linked pieces then join the slot on the first one to the center that is unoccupied, make a chain of three long doing the saame thing, then bring the one open slot to the unoccupied center.

3D_PrintExplorer1 year ago

Amolen Paper White / Polar Bubblegum

PrinterBambu Lab A1

MaterialPLA

cheqsout1 year ago

Fun simple design.

PrinterBambu Lab P1S

MaterialPLA

ymcdonald2 years ago

Nice, very nice !!! Thanks

Dragonsblood3D2 years ago

I will post pictures after I get home but I did print this out three times. The third time I won't do again. I enlarged it 150% all I can say is Yikes!! This was very difficult to put together at that large of a scale. But now I know what not to do.

RuvenBals2 years ago

Hey, yea, scaling stuff is always difficult. The problem is this: When you scale something, everything gets bigger or smaller. If the design has tolerances, they need to be the same for all sizes. But by scaling them, those tolerances also get bigger or smaller. That can cripple some designs.

Sue_Bernau2 years ago

I printed it but cannot get it together. They do not push together at all and I hate to take a hammer to it. Will keep trying.

Sue_Bernau2 years ago

I got it. My mistake was sliding one slot into the slot of the second piece. Slide the slot of one onto another piece at the three position and add another piece until it makes a ring. Works really well and is fun to fidget with.

RuvenBals2 years ago

Oh, ill make that clear, ty!