Let’s be honest, who is really taking the time to spread out a kitchen towel tidy over a bar? And If you are using a hook - it is often a struggle to find the loop and the towel is probably still wet after a few hours. This simple and well working solution is a mix between the two options. Just throw the towel over and don’t worry about it not drying or falling down.

You can either screw or glue it onto your wall or cabinet. There are various glue or tape products for wall fixation out there. I used 3M Tape.

Diameter of the two screw holes: 5,5mm

Size: ca 175 × 75 × 50 mm

Print settings Required build volume: 180 x 180 x 60 mm Material usage: 40g Print time: 4h – 5h

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm – 0,28 mm Outer walls: 3 Infill: 20% Build plate adhesion type: none