We created the Dragon's Breath Bookend! A complete dragon-blowing fire that crashes against books or a wall! Along with the stand-alone dragon, I have also included a male and female dragon rider version. The dragon is pretty large at 100% scale! Don't be afraid to scale it down a bit to fit your space.

We worked hard to make these models require little support. I have also included .3mf fully colored files. Below is how many grams of filament are needed, and support settings.

Filament Usage (Solo dragon as pictured- no rider) Dragon Body- 147 grams Two Wings- 96 grams Tail- 34 grams Flame- 212 grams

Filament Usage (Multi-Color Dragon Rider) Dragon Body with Rider- 369 grams Two Wings- 96 grams Tail- 34 grams Flame- 212 grams

Filament Usage (Single Color Dragon Rider) Dragon Body with Rider- 130 grams Two Wings- 96 grams Tail- 34 grams Flame- 212 grams

As always, tag me in your post so I can share your work with my followers!

Happy printing! Christian, @CraftyKid3D

3D printing settings: In case you can't use my pre-sliced files, here are some important settings-

-I made a support blocker for the mouth of the dragon. The teeth don't need support. -I use a brim for the wings so they don't tip over while printing. -I used Hybrid tree supports, Threshold angle 35 degrees, On build plate only, Remove small overhangs -.16 layer height, 5% gyroid infill, 3 walls.