The Mandalorian
This Mandalorian figure is easy to print, requiring no supports, MMU/AMS, or glue and is a blast to assemble! It functions the same as my other BIG BRICK models, which are all derived from my base model: Generic Figure.
Printing Instructions:
- STLs already in suggested printing orientation
- No supports needed
- I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. In particular, the hands and arms can cause issues if there is poor adhesion.
Filament Used In Pictures
This is a list of the filament I used while making this model. I receive no money from you clicking these links, and there may be better choices. This is just what I had available and what I thought looked good! Hope it helps :)
Required Parts/Tools for Assembly:
- 3D Printed Parts [Filament]
- Body
- 1x - Head - [Army Beige]
- 1x - Torso - Brown Part [Army Brown]
- 1x - Torso - Silver Parts [Silver]
- 1x - Arms - Brown Parts(brim may be helpful, connector portion may print uncleanly, this is okay!) [Army Brown]
- 1x - Arms - Silver Parts [Silver]
- 1x - Hands (brim may be helpful) [True Black]
- 1x - Waist Assembly - Brown Parts [Army Brown]
- 1x - Waist Assembly - Silver Part [Silver]
- 1x - Legs - Brown Parts [Army Brown]
- 1x - Legs - Silver Parts [Silver]
- Accessories
- 1x - Helmet [Silver]
- 1x - Visor [True Black]
- 1x - Jetpack Assembly [Silver]
- 1x - Pistol Assembly [True Black]
- 1x - Rifle Assembly [True Black]
- 1x - Cape Template - Full OR Half [Any]
- Tools (ALL OPTIONAL)
- Super Glue (for holding figure in one position/pose if desired)
- Small Allen Wrench (to twist on part of waist assembly)
- Black Marker (to color in the visor)
Assembly Instructions:
Each of my BIG BRICK models are built from the same base model and the majority of the assembly is the same for each of them. You can find detailed assembly instructions for my models on that base model's designer post here: Generic Figure. You can find all other instructions relating to this model specifically below. Enjoy!
Torso and Legs: The silver parts that go in the torso and legs all just press fit into the brown parts. They should all slide in loosely at first and get tighter the deeper they get. Just match the pictures and press hard :)
Jetpack: To assemble the jetpack, start by sliding the jetpack mount over the neck of the torso before the head has been attached. Make sure the L-shape of the mount is facing down over the model's back. Before attaching the jetpack itself, make sure to insert the two jetpack rockets into the holes in the jetpack. Once that is completed, simply slide the jetpack down onto the mount. This must be done before sliding the helmet on.
Weapons: There are two dovetail pins included with each of the guns. I recommend sliding the longer one into one half of the gun, then slide the other half of the gun onto this pin until both halves are aligned. Finish by inserting the shorter pin into the handle of the gun.
Cape: If you have a big enough bed, you can print the full cape template, or you can print the half version. If you print the half version, just make sure when cutting it out of whatever material you choose, you mirror the template along the straight line down the middle.