Luke Skywalker
This Luke Skywalker figure is easy to print, requiring no supports, MMU/AMS, or glue and is a blast to assemble! It functions the same as my other BIG BRICK models, which are all derived from my base model: Generic Figure.
Printing Instructions:
- STLs already in suggested printing orientation
- No supports needed
- I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. In particular, the hands and arms can cause issues if there is poor adhesion.
Filament Used In Pictures
This is a list of the filament I used while making this model. I receive no money from you clicking these links, and there may be better choices. This is just what I had available and what I thought looked good! Hope it helps :)
- eSUN Silver
- Polymaker Army Beige
- Polymaker Army Brown
- Polymaker Cotton White
- Polymaker Pastel Ice
- Polymaker Wood Brown
Required Parts/Tools for Assembly:
- 3D Printed Parts [Filament]
- Body
- 1x - Head [Army Beige]
- 1x - Hair Assembly [Wood Brown]
- 1x - Torso - White Part [Cotton White]
- 1x - Torso - Tan Part [Army Beige]
- 1x - Torso - Silver Part [Silver]
- 1x - Torso - Brown Parts [Army Brown]
- 1x - Arms (brim may be helpful, connector portion may print uncleanly, this is okay!) [Cotton White]
- 1x - Hands (may be helpful to add a brim) [Army Beige]
- 1x - Waist Assembly [Cotton White]
- 1x - Legs - White Parts [Cotton White]
- 1x - Legs - Brown Parts [Army Brown]
- Accessories
- 1x - Lightsaber Handle [Silver]
- 1x - Lightsaber Blade [Pastel Ice]
- Tools (ALL OPTIONAL)
- Super Glue (for holding figure in one position/pose if desired)
- Small Allen Wrench (to twist on part of waist assembly)
Assembly Instructions:
Each of my BIG BRICK models are built from the same base model and the majority of the assembly is the same for each of them. You can find detailed assembly instructions for my models on that base model's designer post here: Generic Figure. You can find all other instructions relating to this model specifically below. Enjoy!
Hair: The hair assembles via a simple twist-lock mechanism. First, insert the lock ring into the lower half of the hair and twist clockwise to lock it in place. It doesn't matter which side of the ring is up or down, it is the same either way. Then align the top of the hair onto the bottom half and twist it into place. Just make sure when you twist it into place everything lines up correctly! There are only 3 different possible positions, so if you can't tell at first, just try one and go from there :)
Torso: The tan, silver, and brown torso parts simply press fit into the white torso part as seen in the model photos.
Legs: The white inserts simply slide from the inside of each leg towards the outside. The white parts cannot be assembled into the opposite leg, so you can't mess it up :) See images below.