Hat Collection

I've had some requests for props and different options for the generic figure that I released so this Hat Collection is my second installment in a series of different collections that I plan on releasing! All of these props will fit with any of my figures :)

Printing Instructions:

• STLs already in suggested printing orientation
• No supports needed
• I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. For the heads, an inside brim is always safe and very easy to remove afterward!

Assembly Instructions:

The only hat that requires assembly is the curved baseball cap. The assembly is very simple, just insert the four pins into one side of the hat, then press the other side onto it. finish by inserting the dovetail pin from the underside.