Clone Trooper - Phase I
This Clone Trooper figure is easy to print, requiring no supports, MMU/AMS, or glue and is a blast to assemble! It functions the same as my other BIG BRICK models, which are all derived from my base model: Generic Figure.
Printing Instructions:
- STLs already in suggested printing orientation
- No supports needed
- I would always recommend using a brim if you're not certain about the bed adhesion of any of these parts. In particular, the hands and arms can cause issues if there is poor adhesion.
Filament Used In Pictures
This is a list of the filament I used while making this model. I receive no money from you clicking these links, and there may be better choices. This is just what I had available and what I thought looked good! Hope it helps :)
Required Parts/Tools for Assembly:
- 3D Printed Parts [Filament]
- Body
- 1x - Head [Army Beige]
- 1x - Torso - White Part [Cotton White]
- 1x - Torso - Black Parts[Charcoal Black]
- 1x - Arms (brim may be helpful, connector portions may print uncleanly, this is okay!) [Cotton White]
- 1x - Hands (may be helpful to add a brim) [Charcoal Black]
- 1x - Waist Assembly [Cotton White]
- 1x - Legs - White Parts [Cotton White]
- 1x - Legs - Black Parts [Charcoal Black]
- Accessories
- 1x - Helmet - White Parts [Cotton White]
- 1x - Helmet - Black Parts [Charcoal Black]
- 1x - Gun Assembly [Charcoal Black]
- Tools (ALL OPTIONAL)
- Super Glue (for holding figure in one position/pose if desired)
- Small Allen Wrench (to twist on part of waist assembly)
Assembly Instructions:
Each of my BIG BRICK models are built from the same base model and the majority of the assembly is the same for each of them. You can find detailed assembly instructions for my models on that base model's designer post here: Generic Figure. You can find all other instructions relating to this model specifically below. Enjoy!
Helmet: This is the most intricate, and fun part of the assembly! Hope you enjoy it :) Start by sliding the chin piece onto the largest helmet part.
After that, slide the top of the helmet down onto the assembly.
Then insert the side vents into either side. They are not swappable, so ensure the correct orintation before sliding in.
Next, Slide the thin black pieces into the brow and around the back of the head. Like the vents, the back of the head pieces are not swappable, so make sure they are in the correct orientation before inserting.
Insert the visor into the helmet next. This will lock in the chin piece and tie the helmet together :)
Lastly, insert the small square piece into the chin of the helmet.
Torso: The torso assembly is pretty straightforward - the four different inserts simply press into the torso as seen in the picture!
Legs: Start by inserting the black piece into the top of the leg.
Then insert the black piece into the front of the leg. Repeat the process for the other leg.
Weapon: There are two dovetail pins included with the gun. I recommend sliding the longer one into one half of the gun, then slide the other half of the gun onto this pin until both halves are aligned. Finish by inserting the shorter pin into the handle of the gun.